#Signalscope pro ipa how to
#Signalscope pro ipa serial number
#Signalscope pro ipa install
#Signalscope pro ipa Pc

In our example cal file, the Sens Factor is given as –1.3, so the number we enter into the Trim field is: Check the sensitivity calibration number (Sens Factor) in your UMIK-1 calibration file, then work out the following formula: If you cannot do this, try the following. (For best results, use a single tone frequency at 300 Hz or 1 kHz and position the microphone close to a speaker.) Then connect the UMIK-1 to your iPad and adjust the AudioTools Trim level to get the same SPL.

#Signalscope pro ipa Pc

We recommend that you use your UMIK-1 first with Room EQ Wizard on your PC or Mac to generate a test signal at a known level. Please note that miniDSP has no control over the way that AudioTools works, so can not provide support for SPL calibration in AudioTools.

It is helpful to adjust the Trim parameter so that the SPL readings given by AudioTool are correct. The calibration screen will change to display the name, as shown above. Then, back in the AudioTools interface on the iPad, tap on the name of the calibration file and tap Apply. On your computer's browser, enter the address shown by AudioTools on the above screen and upload the calibration file from step 1 above.

#Signalscope pro ipa how to

This will bring up a screen with information on how to transfer the calibration file from your computer to the iPad: Click on the Calibration File link and then on the Files link at the bottom right. Initially, however, this will be blank, so you will need to load the calibration file to the iPad and select it. In the screenshot above, the name of a UMIK-1 calibration file is shown. This will bring up the microphone calibration screen. In this example we have selected 'R Line 1': The measured audio is the same on both left and right channels so it doesn't matter which one you use, just be sure to always select the same one. You will see see that two channels are available for the UMIK-1. Open the app and go to the Settings page, and then select Microphone Setup.

#Signalscope pro ipa install

If you haven't already, install the Audio Tools program on your iPad from the App Store. Alternatively, use a 3.5mm stereo to RCA adapter, as shown at right. On the iPad end, the cable will have a 3.5mm stereo jack, and typically the other end has a pair of RCA connectors, as shown at left in the photograph below. To generate audio output from the iPad, connect a cable from the iPad headphone socket to the system being tested. This photo shows an iPad mini connected to the UMIK-1 via the Lightning to USB adapter: To connect the UMIK-1 to your Apple iPad, you will need the Lightning to USB3 camera adapter or Lightning to USB camera adapter. Mount the UMIK-1 into the small stand supplied with it, or if you like, you can use any other microphone stand.

#Signalscope pro ipa serial number

Each microphone has a unique calibration file, which is why the serial number must be entered.

The calibration file ensures that your microphone is as accurate as possible. Use 'Save As' in your browser to save the numbers as a file e.g. It is in the form xxx-yyyy and labeled on the microphone. Go to the UMIK-1 page and enter your microphone's serial number. You should contact directly Audiotools developpers for any questions you might have for his software. This app note shows you how to set up the miniDSP UMIK-1 to use with AudioTools but other functions of the Apple iPad hardware or the AudioTools app are beyond the scope of miniDSP support. WARNING: miniDSP cannot provide support for third-party applications or hardware. In this application note we will show you how to set up your UMIK-1 for use with the AudioTools app from StudioSix Digital, running on an Apple iPad. The miniDSP UMIK-1 is the perfect companion to audio analysis programs running on your tablet or even your smartphone.